Filter
Top Products
18
Telephone Operation
1
Press
PROG/MEM
.
2
Enter the number you
want to store. (To store the
last number you dialed, sim-
ply press
REDIAL
.)
If you enter a wrong digit, press
PHONE
twice to exit the proce-
dure. Then start over at Step 1.
3
Press
PROG/MEM
then press one of the number buttons (
0
–
9
).
The SP-514 beeps three times.
Note:
If you receive a call while you are storing information in
memory, press
PHONE
to answer the call. A tone sounds. After the
call, begin again at Step 1.
A memory index sticker is supplied with your SP-514. We recom-
mend you write each stored number next to its number key loca-
tion (MEM 1 for number
1
, MEM 2 for
2
, and so on). (Use a pencil
in case you change the stored number.) Peel the backing from the
sticker and attach it to the handset or the base.
To replace a stored number, simply store a new one in its place.
Enterin
g
a Pause
In some telephone systems, you must dial an access code (9, for
example) and wait for a second dial tone before you can dial an
outside number. You can store the access code with the phone
number. However, you should also store a pause after the access
code to allow the outside line time to connect. To do so, hold down
the number immediately preceding the pause until you hear a
second beep. (For example, if 9 is your access code, hold down 9
until you hear a second beep.) This enters a 1.5-second pause.
43-5514.fm Page 18 Wednesday, August 18, 1999 12:47 PM