Filter
Top Products
Basics
Basics 15
US
(SPEAKERPHONE)
SPEAKERPHONE
lamp
VOLUME
control
LINE lamp
(REDIAL/PAUSE)
(FLASH)
(*TONE)
(HOLD)
If the handset battery becomes weak during a call
You hear a beep every three seconds and the TALK/BATT LOW lamp
on the handset flashes.
The call will disconnect soon. Replace the handset on the base phone to
charge.
For optimum performance, charge the battery for a full 12 hours.
Note that during the first 10 - 15 minutes of charging, the phone will be
inactive, i.e., unable to make or receive a call.
After this initial 10 - 15 minutes, you may be able to use the phone, but
the battery duration will be very short; thus it is recommended that
you fully charge the battery before the next usage.
Making calls through the speakerphone
Press (SPEAKERPHONE) on the base phone.
The SPEAKERPHONE lamp and the
LINE lamp light up.
Dial the phone number.
When you are done talking, press
(SPEAKERPHONE) again.
continued
Additional tasks
To
Put a call on hold
Adjust the speaker volume
Switch to tone dialing
temporarily
Switch to another call
(“call waiting” service*)
* You need to subscribe to the service from your telephone company.
Do this
Press (HOLD).
The LINE lamp flashes slowly.
Press (SPEAKERPHONE) to resume the conversation.
Slide the VOLUME control.
Press (*TONE) while using the telephone after
you’re connected.
The line remains in tone dialing until disconnected.
Press (FLASH) to access the flash function.
Press (FLASH) again to return to he first caller.