Filter
Top Products
Basics
Basics 19
US
Receiving calls through the speakerphone
When the phone rings, press (SPEAKERPHONE)
on the base phone.
The SPEAKERPHONE lamp and the
LINE lamp light up.
To adjust the speaker volume, slide
the VOLUME control.
When you are done talking, press
(SPEAKERPHONE) again.
To obtain the best speakerphone
performance, see page 18.
To adjust the ringer volume, see page 24.
1 When you hear the phone ring;
•Press (TALK)
(or any key except (OFF)) .
or
•Pick up the handset from the
base phone when the handset
is placed on the base phone.
The TALK/BATT LOW lamp on
the handset and the LINE
lamp
on the base phone light up.
2 When you’re done talking, press
(OFF) or replace the handset on
the base phone.
The TALK/BATT LOW lamp on
the handset and the LINE
lamp
on the base phone
go off.
Receiving calls
To
Put a call on hold
Select a better channel
Adjust the handset volume
Switch to tone dialing
temporarily
Switch to another call
(“call waiting” service*)
Turn on/off the ringer
of the handset
* You need to subscribe to the service from your telephone company.
Additional tasks
Do this
Press (HOLD).
The TALK/BATT LOW lamp flashes slowly.
Press (TALK) to resume the conversation.
Press (CHANNEL).
Set the VOL switch to H (high), M (middle) or L (low).
Press (*TONE) while using the telephone after you’re connected.
The line remains in tone dialing until disconnected.
Press (FLASH) to access the flash function.
Press (FLASH) again to return to the first caller.
See “Setting the ringer type” on page 23.
LINE lamp
(*TONE)
TALK/BATT
LOW lamp
VOL
switch
(CHANNEL)
(HOLD)
(FLASH)
(SPEAKERPHONE)
VOLUME
control
(FLASH)
(*TONE)
SPEAKERPHONE
lamp
(HOLD)