Shure PG185 Wireless Office Headset User Manual


 
PG185 Technical Specifications
Type Condenser, electret bias
Frequency Response 60Hz to 12,000Hz* (see Frequency Chart)
Polar Pattern Cardioid (unidirectional)
Output Impedance 1200Ω @1kHz*
Output Level -47dBV/Pa (4.5 mV)*
Signal to Noise Ratio 66dB, 1kHz at 1 Pa*
Maximum SPL 120dB
Dynamic Range
(max. SPL to A-weighted noise level)
92dB*
Output Noise 28dB (typical, A-Weighted)*
Recommended Operating Voltage +5VDC, 10V max (pin 2 to pin 1)
Polarity Positive sound pressure on diaphragm produces
positive voltage on pins 3 and 4 relative to pin 1
(ground) on the mini TA4F connector
Cable 1.22 m (48 in.) two-conductor shielded
Connector Mini TA4F
Net Weight 23 g (0.81 oz)
Replacement Parts Windscreen (2), Clothing clip...................RK323
*All measurements taken using RK183PK preamp set to 0dB gain
Wearing the microphone
u Attach the lavalier mic
about 15 - 25 cm (6 - 10 in.)
away from the mouth.
v Connect the mic cable
to the bodypack transmitter.
mute
Wiring Diagram
RED (to drain) (DC bias)
BLACK (to source) (audio)
SHIELD
CARTRIDGE
TA4F CONNECTOR