Sanyo CLT-D6622(WH) Cordless Telephone User Manual


 
35
Battery replacement and handling
When the operating time becomes short even after a battery is recharged,
please replace the battery.
With normal usage, your battery should last approximately one year.
For a replacement battery, please contact your place of purchase or ll out and
mail the enlosed form.
CAUTION:
Use only the specied battery pack type (Ni-MH 3.6V, 650mAh).
Do not remove the battery from the handset to charge it.
Never throw the battery into a re, disassemble it, or heat it.
Do not remove or damage the battery casing.
Remove battery if storing the phone for over 30 days.
Make sure the telephone is off before you replace the battery.
1. Slide off the battery compartment cover.
2. Remove the battery pack from the compartment.
3. Insert the new battery pack according to the polarity engraved.
NOTE: Please refer to the TO INSTALL A REPLACEMENT BATTERY PACK
section Page 12.
4. Put the battery compartment cover back on.
5. Place handset on the base to charge for 15 hours.
Charge the handset battery for 15 continuous hours prior to rst use. The initial
battery charge is important for best performance.
CAUTION:
To reduce the risk of re or personal injury, use a NI-MH 3.6 V,
650mAh battery.
Replacement part number : 3SN-AAA
CHANGING THE BATTERY
When power is off, you will not be able to make or receive calls with the
telephone.
POWER FAILURE