Filter
Top Products
12
Failure to enter the time using the 24 hour clock will cause the date to change at
12:00 P.M.Open customer programming and follow the instructions below.
ACTION DISPLAY
1. Press TRSF and then dial 505 OLD:6010184:0047
Display shows NEW:WMMDDYY:HHMM
2. Enter the new time and date using OLD:6010184:0047
the above format NEW:3020994:1445
3. Verify the time and date and reenter OLD:3020994:1445
them if necessary NEW:WMMDDYY:HHMM
4. Press TRSF to store and exit
programming OR press SPK to store
and advance to the next program
If you have entered invalid data,you will receive an [ INVALID ENTRY ] message for
three seconds.Reenter the correct date and time.If the information you entered is
incorrect,repeat the procedure.
RESET STATION PASSCODES
TO DEFAULT
Individual keyset users can set or change their own individual passcodes. These
passcodes are used to lock and unlock keysets,override toll restriction and access
the DISA feature. At times, it may be necessary for the system administrator to
reset a station’s passcode to default “1234.”This program cannot be used to display
passcodes,only to reset them.
PROGRAM KEYS
UP & DOWN - Select the extension number.
HOLD - Press to reset the passcode.
Open customer programming and follow the instructions below.
ACTION DISPLAY
1. Press TRSF and then dial 101 [201
] PASSCODE
Display shows PASSCODE:✱✱✱✱
sys_screen.qxp 5/11/2006 6:26 PM Page 19
13
2. Dial the station number OR use the [205] PASSCODE
UP and DOWN keys to scroll through PASSCODE:✱✱✱✱
the keyset numbers and press the
right soft key to move the cursor right
3. Press HOLD to reset the passcode [205] PASSCODE
PASSCODE : 1234
4. Press the right soft key to return to
step 2 OR press TRSF to store and exit
programming OR press SPK to
store and advance to the next program
DEFAULT DATA: ALL STATION PASSCODES = 1234
PROGRAM STATION NAMES
This program is used to assign a character name or identification for each exten-
sion.You may assign a name of 11 characters long.
PROGRAM KEYS
UP & DOWN - Used to scroll and move cursor.
KEYPAD - Used to enter characters.
HOLD - Press to clear entry.
Open customer programming and follow the instructions below.
ACTION DISPLAY
1. Press TRSF and then dial 104 [2
01] STN NAME
Display shows
2. Dial station number (e.g.,205) [205] STN NAME
OR press UP or DOWN to select the
station and press the right soft key to
move the cursor
3. Enter the station name using the [205] STN NAME
procedure described on the next page SAM SMITH
and press the right soft key to return to
step 2
sys_screen.qxp 5/11/2006 6:26 PM Page 20