Filter
Top Products
13
Preparation
If the receiver is within the range, it beeps and
PAGED
appears for 30 seconds.
If
PAGED
does not appear, move the receiver closer to the
transmitter and press
PAGE
again. If it still does not beep,
repeat the steps under “Setting the System’s Identification
Code” on Page 12 to verify that the identification code is
properly set.
The receiver checks the range every three hours. If the receiver
is out of the range of the transmitter,
OUT
OF
RANGE
appears.
Move the receiver closer to the transmitter and press
PAGE
to
check the range again.
Note:
The transmitter can support an unlimited number of re-
ceivers. The distance between receivers should be 2 feet or
more to avoid interference.
SETTING THE DISPLAY CONTRAST, ALERT
TONE, AND CLOCK DISPLAY FORMAT
1. Hold down
SET
and
9
99
9
DOWN
for about 5 seconds until
SETTINGS
appears.
2. Press
9
99
9
DOWN
to set the display contrast (the default set-
ting is 2).
3. Repeatedly press
SET
to select the contrast level (1–4),
then press
9
99
9
DOWN
. The current tone setting appears.
(The default setting is
BEEP
OFF
.)
4. Press
SET
to toggle between
BEEP
ON
and
BEEP
OFF
,
then press
9
99
9
DOWN
. The display shows the current clock
format setting (the default setting is a 12-hour format).
43-940.fm Page 13 Tuesday, April 25, 2000 1:04 PM