Filter
Top Products
3
1 Plug the telephone line
cord into the base and
into a modular jack.
2 Plug the power supply
cord into the base, and
then the power supply in
an AC outlet.
MODULAR JACK REQUIREMENTS
You need an RJ11 type modular jack, which is the most
common type of phone jack and might look like the one
pictured here. If you don’t have a modular jack, call your
local phone company to find out how to get one installed.
PAGE/FIND
IN USECHARGE
1
2
3
4
5
6
7
8
9
0
AREA CODE PHONE NUMBER
OR
1
4
7
8
*
0
#
ABC DEF
JKL MNO
TUV
GHI
PRS WXY
OPER
MEMORY FLASH REDIAL
TONE
PAGE/FIND
IN USECHARGE
56
9
23
PHONE CHANNEL
ON/OFF
5 Place handset in the base (facing either
direction) to charge for 12 hours.
The CHARGE/IN USE light comes on
indicating that the battery is charging.
6 Turn on the RINGER switch so the
handset rings for incoming calls.
NOTE: Use only the Thomson 5-2348 power supply that came with this unit.
Using other adapters may damage the unit.
3 Raise the base antenna.
4 Set the PULSE/TONE switch to TONE for Touch-Tone service, or PULSE
for rotary service. If you don’t know which type of service you have,
check with the phone company.
LSE/TONE
PULSE/TONE switch
INSTALLATION AND SETUP
RINGER switch
CHARGE/IN USE light