Filter
Top Products
17
Register
From the Phone Setting Menu:
1. Press the VOL (- or +) button to scroll to Register.
2.
Press SELECT soft key. “Press base unit page button until beep” shows
in the display.
3.
Press and hold the Page button on base for 5 seconds.
4.
“Registration” displays to indicate the base is now in registration mode.
5.
If the registration is successful, the handset shows “Registration
complete” for 2 seconds and emits a confirmation tone.
6.
If the registration is failed (i.e. timeout), the handset shows
“REGISTRATION FAILED!” for 2 seconds and emits an error tone.
Remove Handset
De-registration cancels registration. During the de-registration process,
keep the handset near the base.
WARNING: It is not recommended that a handset be
deregistered unless absolutely necessary because once a
handset is deregistered, that handset’s telephone features
cannot be used until the handset is re-registered.
From the Phone Setting Menu:
1.
Press the VOL (- or +) button to scroll to the Remove handset.
2.
Press SELECT soft key. “Remove handset?” shows on the display.
3.
Press the YES soft key to confirm de-registration. “Saved” shows in the
display and then shows “Press “REG” to initiate registration” in the
handset.
NOTE: You can press the REG soft key to enter the registation mode again.
De-Register (Only applicable for base)
From the Phone Setting Menu:
1. Press the VOL (- or +) button to scroll to the Deregistration.
2.
Press SELECT soft key. The list of all registered handsets will be shown,
and use the VOL (- or +) button to scroll to your selection.
3.
Press the SELECT soft key. “Remove handset?” shows on the display.
4.
Press YES soft key to confirm de-registration. “Saved” shows in the
display and then shows “Press “REG” to initiate registration” in the
handset.
Programming the Telephone