Filter
Top Products
PPM3 Page 24
known good cables between the stereo, line level source, and PPM3. Try
switching cables or using a different cable if you’re having audio trouble.
PROBLEM: The microphone doesn’t work.
SOLUTION: Test the microphone with another unit to be sure it works on its
own. Make sure it’s plugged solidly into the jack on the PPM3 and be sure that
the “Mic Mute” button is pressed.
PROBLEM: One or more of my LEDs are not lighting.
SOLUTION: First of all, check to be sure you’ve got the LEDs installed
correctly. Each LED has a flat side that corresponds to the negative or
cathode lead of the part. Read back in the assembly instructions and make
sure that the flat side and negative lead are placed correctly. If the power-on
LED is not working make sure you have a good input voltage source and that
it is plugged securely into the power jack on the PPM3. Ok, it seems simple
but make sure the power switch is pressed. If the “Mic Mute” LED is not lit,
check to be sure that that switch is pressed. The same goes for the “Clip”
LED; you must have the “Phone Mute” button pushed and there must be
enough audio level to cause the “Clip” LED to light.
PROBLEM: I just can’t make the &#^$^@! thing work!
SOLUTION: Call Ramsey Support at 1-585-924-4560 or look at the warranty
in this manual. We are here to help and reduce your frustration as much as
possible. It is usually something simple. Have your board revision handy to
help our technicians find the proper schematic for your needs. You can email
our tech support as well at the ramseykits.com website. Oh, please count to
ten before calling, taking some deep breaths first...