Filter
Top Products
9
PREPARATION
SETTING THE DAY AND
TIME
Follow these steps to set the day and
time so the TAD records the correct day
and time of the call with each phone
message.
Notes
:
• To avoid having to reset the time if
AC power is lost, we recommend
you install a battery before you set
the day and time.
• If you do not complete any step
within 8 seconds, the TAD sounds a
three-tone beep and stops setting
the day and time. Start over at Step
1
1. Press and hold
SET
until the TAD
beeps. The TAD announces, “Sun-
day,” and
01
appears on the dis-
play.
Note
: If necessary, adjust
VOLUME
on the right side of the TAD to the
desired listening level.
2. To change the day of the week,
repeatedly press
REPEAT
to move
backward or
SKIP
to move forward
until the TAD announces the
desired day of the week.
3. Press
STOP
. The TAD beeps once
and announces the time format,
“AM” or “PM.”
4. To change the hour, repeatedly
press
REPEAT
until you hear the
desired hour.
5. Press
STOP
. The TAD beeps once
to confirm the hour setting.
6. To change the minutes, repeatedly
press
REPEAT
until you hear the
desired minute setting.
7. Press
STOP
to confirm the settings.
The TAD beeps and announces the
day and time.
To check the current day and time at
any time, press
SET
.
43-799.fm Page 9 Monday, August 16, 1999 9:43 AM