Filter
Top Products
13
If the incoming message tape is full, the TAD-716 an-
swers a call after 10 rings, plays back the outgoing mes-
sage, then waits 7 seconds for you to enter the remote
operation security code. If you do not enter the correct
code, the TAD-716 beeps and hangs up.
Rotate
VOLUME
counterclockwise to increase the vol-
ume, or clockwise to decrease it.
To have the TAD-716 not answer calls, turn it off by rotat-
ing
VOLUME
clockwise until it clicks. The message indica-
tor turns off.
SCREENING CALLS
To screen calls, let the TAD-716 answer them. Listen to
the caller's message through the TAD-716's speaker. If
you decide to answer the call, pick up any phone on the
same phone line as the TAD-716. The TAD-716 stops re-
cording and resets to answer the next call.
Note:
If you pick up the phone just as the TAD-716 an-
swers, the TAD-716 might not stop recording the mes-
sage. If this happens, press the telephone’s switchhook
for about one second. The TAD-716 stops and resets to
answer the next call.