Filter
Top Products
16
CHANGING THE REMOTE
OPERATION SECURITY
CODE
The remote operation security code is
preset to 784, but you can change it by
following these steps.
Note
: Be sure to set each digit within 8
seconds. Otherwise, you must start over
from Step 1.
1. Hold down
CODE/SKIP
until the TAD
beeps once.
Co
appears.
2. Press
CODE/SKIP
again.
Sc
(securi-
ty code) and the digits of the current
code appear in sequence, then the
first digit reappears.
For example, when the security
code is 784, the display shows
Sc
(security code),
–
7
,
–8
,
–
4
, then
–
7
reappears.
3. Repeatedly press
SKIP/CODE
or
MEMO/REPEAT
to set the first digit,
then press
ANSWER
. The second
digit appears.
Note
: If you enter an incorrect digit,
press
STOP/TIME SET
, then repeat
the procedure.
4. Press
SKIP/CODE
or
MEMO/REPEAT
to set the second digit, then press
ANSWER
. The third digit appears.
5. Press
SKIP/CODE
or
MEMO/REPEAT
to set the third digit, then press
AN-
SWER
. The TAD sounds a long
beep.
To check the remote operation security
code at any time, follow Steps 1 and 2,
then press
STOP/TIME SET
to exit.
43-784.fm Page 16 Monday, August 16, 1999 7:47 AM