Filter
Top Products
11Caller ID Operation
USING TONE
SERVICES ON A
PULSE LINE
Some special services require
tone signals (such as bank-by-
phone). If you have pulse dialing,
you can still use these special
tone services by following these
steps.
1. Be sure
PULSE/TONE
is set to
PULSE
.
2. Dial the service’s main num-
ber.
3. When the service answers,
press
TONE
. Any additional
numbers you dial are sent as
tone signals.
The phone’s dial mode resets to
pulse when you make or receive
a call.
ˆ
Caller ID Operation
If you subscribe to Caller ID ser-
vice from your phone company,
the phone company sends infor-
mation about the call, as well as
the time and date, between the
first and second rings of every call
you receive.
The phone displays this informa-
tion when it receives a call, and it
stores up to 60 Caller ID records
for later review. It also shows if
caller information is unavailable
or if the name and number were
blocked by the caller (see “Caller
ID Messages” on Page 12).
If you subscribe to Call Waiting
with Caller ID, flashes along
with the Caller ID record for the
new call. If you want to answer
the incoming call, press
CALL
BACK/FLASH
. To resume the previ-
ous phone conversation, press
CALL BACK/FLASH
again.
If the phone’s Caller ID memory
becomes full, any new call replac-
es the oldest call’s record.
REVIEWING CALLER
ID RECORDS
To review the Caller ID records,
repeatedly press
▲
or
▼
.
NEW-
XX TOTAL-XX
appears, show-
ing the number of new Caller ID
records, if any, and the total num-
ber of records appears. Press
▲
or
▼
again, and the latest record
appears.