Filter
Top Products
12
8. Press and lift out the handset
holder, rotate it 180°, then snap it
back into place so it holds the
handset.
9. Raise the base’s antenna to a ver-
tical position and fully extend it.
CONNECTING AND
CHARGING THE
BATTERY
The ET-596 comes with a recharge-
able nickel-cadmium battery installed
in the handset. Before using your
phone, you must connect the battery
then charge it for about 14 hours.
1. Remove the screw from the bat-
tery compartment cover on the
bottom of the handset, then press
down and slide off the handset’s
cover.
2. Plug the battery pack’s plastic
connector into the phone’s socket.
The connector fits only one way.
3. Replace the cover and tighten the
screw.
43-696a.fm Page 12 Friday, August 13, 1999 12:48 PM