Filter
Top Products
MOUNTING
THE
PHONE
Desk Mounting
Wall Mounting
(With or Without Wall Plate)
ÐÐ
Switch to
TONE
or
PULSE
to
match the type of service you
have. If you have pulse service,
you can switch to
TONE
during a
call to use tone services.
Press
FLASH
to produce a timed switchhook
signal for special services such as Call Wait-
ing.
Press to dial the last number
dialed (up to 31 tone or 32
pulse digits).
Press to end a call.
Plug the handset cord
into the jacks on the
base and handset.
Set the ringer to
ON
or
OFF
. You
can make calls with the ringer off,
and you can receive calls if you
hear another phone on the same
line ringing.
Note
: If you do not subscribe to any special
services, pressing
FLASH
might disconnect
the call.
Press
HOLD
to hang up the handset
without disconnecting the call. The indi-
cator lights. To release a call from hold,
lift the handset from the cradle or hold
down the switchhook for 1 second.
The indicator lights when
a call is on hold.
USING THE PHONE
This symbol is intended to inform you
that parts inside the telephone present
a risk of electric shock.
This symbol is intended to alert you to
important operating and servicing
instructions included in the papers with
the telephone.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Note:
The USOC number of the jack to be installed is
RJ11C (RJ11W for a wall jack).
1997 Tandy Corporation.
All Rights Reserved.
Radio Shack is a registered trademark used by Tandy Corporation.
Handset Holder
(Wall Mounting)