Filter
Top Products
8
5. Plug the modular cord’s other end
into the wall plate jack, then align
the base’s keyhole slots with the
wall plate studs and slide the base
downward to secure it.
6. Plug the adapter into a standard AC
outlet.
7. Press and lift out the handset
holder, rotate it 180°, then snap it
back into place so it holds the hand-
set.
8. Lift the base’s antenna to an upright
(vertical) position.
Note:
To mount the ET-1119 directly on
a wall, you need two screws (not sup-
plied) with heads that fit into the keyhole
slots on the bottom of the base.
Follow the steps under “On a Wall Plate
or Wall” on Page 7, then apply these ad-
ditional instructions for placement on a
wall.
1. Drill two holes 3
15
/
16
inches (100 mm) apart.
Then thread a screw into
each hole, letting the
heads extend about
5
/
16
inch (8 mm) from the
wall.
2. Plug one end of the supplied long
modular cord into the
TEL
LINE
jack
on the back of the base.
3. Align the base’s keyhole slots with
the mounting screws and slide the
base downward to secure it.
INSTALLING AND
CHARGING THE BATTERY
PACK
The ET-1119 comes with a recharge-
able Ni-Cd battery pack. Before using
your phone, you must install the battery
pack, then charge it for about 24 hours.
5
/
16
3
15
/
16
43-1119.fm Page 8 Thursday, September 16, 1999 1:58 PM