Filter
Top Products
15
• We recommend you not use REDIAL
to dial numbers that include a tone
entry. This could result in a wrong
number being dialed. (See “Using
Tone Services on a Pulse Line.”)
• The redial memory does not store a
flash entry or any digits entered af-
ter you press
FLASH (see “Using
Flash”).
USING FLASH
FLASH performs the electronic equiva-
lent of a switchhook operation for special
services, such as Call Waiting.
For example, if you have Call Waiting,
press
FLASH to answer an incoming call
without disconnecting the current call.
Press
FLASH again to return to the first
call.
Note:
If you do not have any special
phone services, pressing
FLASH might
disconnect the current call.
USING TONE SERVICES
ON A PULSE LINE
Some special services, such as bank-by-
phone, require tone signals. If you have
pulse service, you can still use these
special tone services by following these
steps.
1. Be sure
T/P is set to P.
2. Press
TALK and dial the service’s
main number.
3. When the service answers, press
. ✱ appears. Any additional num-
bers you dial are sent as tone sig-
nals.
4. After you complete the call, return
the handset to the base or press
TALK. The phone automatically re-
sets to pulse dialing.
USING PAGE
To page the person who has the handset
or to locate the handset when the phone
is not in use, press
PAGE on the base.
The handset beeps twice per second for
15 seconds and
PAGING appears. The
MESSAGE indicator flashes while the
handset beeps.
To stop the handset from beeping before
it automatically stops, press any key on
the handset or
PAGE on the base.
Note
: You cannot page the handset dur-
ing a call.
MEMORY DIALING
You can store up to 20 phone numbers in
memory, then dial a stored number by
pressing a two-digit memory location
number.
PAGE
43-1105.fm Page 15 Monday, August 30, 1999 1:57 PM