Radio Shack ET-1102 Cordless Telephone User Manual


 
4
Important:
Cordless phones such as this one
require AC power to operate. When
the AC power is off, you cannot dial
out or receive incoming calls using
your ET-1102. To be safe, you
should also have a phone that does
not need AC power to operate (not a
cordless phone) so you can still
make and receive calls if there is an
AC power failure.
When AC power is lost, the ET-1102
loses the security access-protection
code connection between the base
and the handset. When power is re-
stored, put the handset on the base
briefly to restore this connection so
you can use the handset.
READ THIS BEFORE
INSTALLATION
We have designed your phone to con-
form to federal regulations and you can
connect it to most phone lines. However,
each device that you connect to the tele-
phone line draws power from the line.
We refer to this power draw as the
phone’s
ringer
equivalence
number
, or
REN. The REN is on the bottom of your
phone.
If you use more than one phone or other
device on the line, add up all the RENs.
If the total is more than five, your phones
might not ring. In rural areas, a total
REN of three might impair ringer opera-
tion. If ringer operation is impaired, re-
move one of the devices from the line.
FCC STATEMENT
Your telephone complies with Part 68 of
FCC Rules
. You must, upon request,
provide the FCC registration number
and the REN to your phone company.
These numbers are on the bottom of the
base.
You must not connect your phone to any
of the following:
coin-operated systems
party-line systems
most electronic key phone systems
This equipment complies with the limits
for a Class B digital device as specified
in Part 15 of
FCC
Rules
. These limits
provide reasonable protection against
radio and TV interference in a residential
area. However, your equipment might
cause TV or radio interference even
when it is operating properly. To elimi-
nate interference, you can try one or
more of the following corrective mea-
sures.
Reorient or relocate the receiving
antenna.
Increase the distance between the
equipment and the radio or TV.
Use outlets on different electrical cir-
cuits for the equipment and the ra-
dio or TV.
Consult your local Radio Shack store if
the problem still exists.
43-1102.fm Page 4 Tuesday, August 17, 1999 4:37 PM