Radio Shack 43-3522 Cordless Telephone User Manual


 
5
Plug the modular cord’s other end into
a modular phone line jack.
Plug the supplied AC adapter’s barrel
plug into the
DC 12V 200mA
jack on the
back of the base.
Plug the adapter into a standard AC
outlet.
Connecting, Charging, And
Replacing The Battery Pack
The phone comes with a rechargeable
nickel-cadmium battery pack. You
must connect the battery pack and
charge it for at least 15 hours before
you use the phone for the first time.
1. Use a Phillips screwdriver to
remove the screw on the battery
compartment cover, then remove
the cover.
2. Plug the battery pack’s connector
into the socket in the compartment
(the connector fits only one way).
3. Replace the cover and secure it
with the screw.
To charge the battery pack, place the
remote keypad on the base. The IN
USE/CHARGE indicator.
Notes:
Recharge the battery pack when
the TALK/LOW BATT indicator
lights.
When you first use the phone after
charging or recharging the battery
pack, the phone might not work.
Return the remote keypad to the
base for about 5 seconds to reset
the security access-protection
code.
About once a month, fully
discharge the battery pack by
keeping the remote keypad off the
base until the TALK/LOW BATT
indicator lights. Otherwise, the
battery pack loses its ability to fully
recharge.
If the IN USE/CHARGE indicator
does not light when you place the
remote keypad on the base, be
sure the AC adapter is correctly
and securely connected. Also,
check the charging contacts on
the remote keypad and the base.
If the contacts are dirty or
tarnished, clean them with a
pencil eraser.
When the remote keypad is on the
base, the IN USE/CHARGE
indicator lights even when the
battery pack is not connected. If
your phone does not work, be
sure the battery pack is properly
connected.
If the battery pack becomes
completely discharged or the base
loses power while the remote
keypad is away from it, place the
remote keypad on the base for
about 5 seconds to reset the
security access-protection code. If
the remote keypad loses power,