Filter
Top Products
4 5
FRS-105
USING THE RADIO
Speaker
To talk
, hold the radio
straight up and down
with the microphone
at least 2 inches from
your mouth, then hold
down
PUSH TO TALK
and speak into the
microphone. When
you finish speaking,
release
PUSH TO
TALK
. (Do not touch
the antenna while you
press
PUSH TO TALK
.)
To hear every-
thing happening
on a channel,
including weak
transmissions
and radios set to
a different quiet
code, hold down
MONITOR
.
Release
MONI-
TOR
to turn auto-
squelch back on.
To connect an external microphone
or earphone,
pull up the accessory
cover on the side of the radio, then
plug the microphone’s
3
/
32
-inch plug
into the radio’s microphone jack or
the earphone’s
1
/
8
-inch plug into the
radio’s earphone jack.
Note:
Your local RadioShack store
has a wide selection of external mi-
crophones and earphones.
To remove the attached belt
clip, slide it up while using your
fingernail to pull the belt clip’s
tab toward you. To reattach the
belt clip, slide it down onto the
back of the radio until it clicks.
Listening Safely
To protect your hearing, follow these
guidelines when you use an earphone.
• Set the volume to the lowest setting
before you begin listening. Then
adjust the volume to a comfortable
level.
• Don’t listen at extremely high vol-
ume levels.
• Once you set the volume, don’t
increase it.
Traffic Safety
Do not wear an earphone
while operating a motor vehi-
cle or riding a bicycle. This can
create a traffic hazard and
could be illegal in some areas.
Even though some earphones
let you hear outside sounds
when listening at normal vol-
ume levels, they still can
present a traffic hazard.
To turn the radio on and off and control the volume
To select a channel
Tab
Microphone
Accessory
Cover
Belt Clip
21-1805.fm Page 4 Thursday, August 5, 1999 2:25 PM