Filter
Top Products
SpectraLink 8002 Wireless Telephones Configuration and Administration (SIP)
18 PN: 1725-36034-001_B.doc
Startup Sequence
The SpectraLink 8002 Wireless Telephone goes through an
initialization sequence at startup. The line icons 1-9 display and count
down as the handset steps through this sequence. This is usually very
rapid. If there is difficulty at any step that prevents initialization from
continuing, an error message will display and the related icon(s) will
stay on. Please see the error table at the back of this document for
instructions on how to handle error messages that occur during
initialization.
Icon The icon(s) shown in bold turns off when:
123456789
The handset has located and authenticated and associated with at least one AP, and is
proceeding to bring up higher-layer networking functions.
12345678
The handset is either configured for Static IP, or if configured for DHCP, the DHCP
discovery process has started.
1234567
If DHCP is configured, a DHCP response was received which contains a good DNS
server configuration.
123456 Indicates Static IP configuration.
12345
All networking functions are complete (notably, DHCP) and the handset is establishing
its connection to the LAN.
1234 The LAN connection is complete.
123 The handset has located a generic SIP config file.
12 The handset has located a handset-specific SIP config file.
(no icons)
Registering
Handset is attempting to register each of the specified line contacts.
(no icons)
EXT.
XXXXX
Handset has registered with at least one contact on one proxy server. Initialization is
complete. The handset is in standby mode ready to receive and place calls. The line one
contact is displayed.
During the last three steps of this process, the handset contacts the SIP
TFTP server and downloads general information about the proxy
server(s), downloads specific information pertaining to the handset,
registers with the proxy server(s), and verifies handset credentials.
Once this process is complete, the handset is ready to use.