Filter
Top Products
SpectraLink Corporation Link Wireless Telephones and Accessories User Guide
Part Number: 72-0075-09-C.doc Page 15
Link Quad Charger
Link Quad Charger
Model BC4900
(shown with two empty charging bays)
Overview
The Link Quad Charger is designed to simultaneously charge four
PTS360 NiMH (Nickel Metal Hydride) Battery Packs. The Link
Quad Charger is only authorized for use in the U.S. and Canada.
The Link Quad Charger may be mounted on a horizontal or vertical
surface.
Power supply
The power supply that is required for this unit is the SpectraLink
part number GCX100A. Set up the Link Quad Charger by plugging
the power supply into the Link Quad Charger and into an
appropriate wall outlet.
A solid red LED above an empty charger slot indicates that the slot
is idle and ready for use. If the LEDs do not light, check the power
supply and plug connection to the charger. If the charger appears to
be plugged in correctly, make sure the wall outlet has power.
Position the Battery Pack in a charging slot by aligning the top of
the Battery Pack with the tracks on the charging slot then gently
sliding the Battery Pack upward onto the charging slot. While the
Battery Pack is in the charging slot, the LED above the slot will
indicate the status of the charging process and/or the Battery Pack.
LED status indicators
Solid Green—the Battery Pack is charging. The Link Quad Charger
takes 60-90 minutes to fully charge a Battery Pack. If the NiMH
Battery Pack is hot or cold when placed in the charger, it may take
longer to charge.
Flashing green—the Battery Pack is fully charged and ready for use.
You may leave a fully charged Battery Pack in the Link Quad
Charger. However, if you remove a fully charged Battery Pack then
replace it in the charger, the charger LED will be solid green until
the charger determines that this Battery Pack is fully charged. It may
take a few minutes to give the flashing green indication.
Solid red or flashing red—the Battery Pack in the charger is no
longer capable of retaining a charge and is not usable. If the Battery
Pack will not charge, do not continue to charge the Battery Pack.
Dispose of it properly and do not attempt to use it in the wireless
telephone. Do not attempt to open or repair a defective Battery
Pack.