SoundStation Premier Installation Instructions and User's Guide
9
If you have a Meridian phone connected
to the Interface Module, and your
SoundStation Premier 500D/550D
is in use, you may use your phone to
break away from the public conference
call to speak privately to the far end(s)
without disconnecting the conference call.
When you lift the handset, all microphones
and the speaker on the console are muted.
The red LED’s will blink to indicate
the mute condition. When the handset
is returned to the cradle, the conference
call is resumed and the LED’s return
to a steady state.
Mute Initiated By the Meridian Phone
conference call had originated on the
conference phone. If the PBX limit has not
been reached, new parties may be added
or dropped as described earlier. Caution:
attempting to move conferences before
the cycle is complete, i.e. before the call
is established, and included or dropped,
will result in dropping all callers if you
subsequently push the
ON/OFF button
on the conference phone.
Your SoundStation Premier 550D may be
adaptable to a larger conference room with
the addition of Extended Microphones.
If not purchased with your SoundStation
Premier 550D, these are available as an
accessory from your Polycom Distributor.
To mute all microphones from the
extended microphone, press
MUTE.
To resume two-way communications,
press
MUTE again. The red LED will
return to green.
An
ON/OFF switch is located on each
of the extended microphones.
By switching to the O position, the LED
MUTE light will turn red and only this
microphone will be shut off. Switching
to the
1 position will turn the
microphone back on.
MUTE
Red LED
Using Extended Microphones With 550D