Filter
Top Products
9
8
Set the IntelliStand switch to
Intellistand off ( ) if you
want to control the handset
lifter with the call control
button on your headset.
Set the Intellistand switch to
Intellistand on ( ) if you
want the handset to auto-
matically pick up when you
take the headset off the
charging cradle.
6”
12”
The minimum recommended separation distance is shown above.
IMPORTANT: Incorrect positioning can cause noise and interference problems.
1
2
1. Slide headset into charging cradle.
2. Gently press down on the headset to ensure that headset is in correct position. Amber
charge indicator light on base will flash while charging and will change to solid amber
when fully charged.
3
IntelliStand
™
off
IntelliStand
on
21
A
D
B
C
1. Plug handset lifter power cord into handset lifter jack on base. Push firmly into base.
2. Position handset lifter under the handset on your phone. Verify that the lifter is located
on top of the telephone speaker. If not, you will need to attach the ringer microphone as
described on page 22.
NOTE: Remove only a tiny piece of mounting tape backing to temporarily stick lifter into
position; you may need to move it later.
3
1
2
3
4
IntelliStand
off
IntelliStand
on
3
1
2
3
4
IntelliStand
off
IntelliStand
on
• 20 minutes = minimum
charge to continue setup
• 3 hours = full charge