Filter
Top Products
7
English
EN
Operate the headset
Enter pairing mode Ensure the headset is off. Press until
LED starts blinking red/blue alternately.
Check battery When rst use: Hold for 2 seconds.
During operation: Hold VOL + and VOL
- simultaneously.
>50%: 1 blue ash
>25%: 2 red ash
<25%: 3 red ash
Turn headset on/off Hold until LED turns on/off.
Play/Pause music Tap
Stop music Hold
Next / Previous track Tap /
Adjust volume Press VOL +/VOL -
Pick up / End a call Tap
Reject a call Hold
Redial the last number Press twice quickly.
Activate voice dialing* Hold until beep occurs.
Mute/Unmute the Mic Double tap during a call.
Transfer a call to a
mobile phone
Hold during a call.
* Available if supported by your mobile phone.
Manage 3-way calls
If your mobile phone and network operator support 3-way-calls, you
can manage 3-way-calls via the headset.
To hold the active call and
accept a waiting call
Press while the 2nd call is
coming in.
To drop the active call and
accept a waiting call
Hold while the 2nd call is
coming in.
To swap a call Press during a call.
LED and sound indication
The red/blue LED ashes alternately. The headset is ready for
pairing.
The blue LED ashes once every 6
seconds.
The headset is connected
to the device.
The blue LED ashes twice every 3
seconds.
The headset is not
connected.
The blue LED ashes once every half
a second.
There is an incoming/
outgoing call.
The blue LED ashes once every
second.
The headset is active on
a call.
The red LED ashes three times and
beeps twice every minute.
The battery is low in
power.
Solid red LED. The headset is charging.
The LED is off. The headset is off./Charging
is nished.
The headset beeps every 5 seconds. The Mic is muted.
Clean the headset
A few ways to clean the headset:
Wipe with clean cloth.•
Wash it under running tape water.•
Caution
Do not dive with this product or immerse it into water. •
4 Use the headset
Connect the headset to your mobile phone
1 With the mobile phone turned on, press until the LED lights
up, to turn on the headset.
Once turned on, the headset reconnects automatically to »
the last device it was connected to.
If the last connected device is not available, the headset »
tries to reconnect to the second to last device that was
connected to the headset. If it cannot nd this device, it
will look for all previously paired devices in the order of
last usage, until it nds a device to connect to. The headset
stores up to eight previously paired devices.
Tip
If you turn on the mobile phone or its Bluetooth feature • after turning
on the headset, connect the headset from the Bluetooth menu of
your mobile phone.
Automatic power saving
If the headset cannot nd any Bluetooth device to connect to in
range within ve minutes, it automatically powers down to save
battery life.
Get the best t
1 Choose the earbuds that best t for your ear canal.
2 Gently blend the ear hook to t into your ears.
3 Adjust the rubber part of the ear hook to the height that you
feel t.
4 Twist the earbuds to the right position for best t and noise
isolation.