Filter
Top Products
8 EN
5 Get started
Charge the headset
Note
Finish your call before charging the headset, as connecting the headset for •
charging will power off the unit.
During charging, you can operate the headset normally.
•
1 Remove the USB cap.
2 Plug the headset into a powered USB port on a PC or into a
power adaptor with USB outlet.
During charging, the LED turns red. The LED turns off when »
the headset is fully charged.
Tip
Typically, a full charge takes 2 hours. •
Pair the headset with your mobile phone
Before you use the headset with a mobile phone for the rst time,
pair it with the mobile phone. A successful pairing establishes a
unique encrypted link between the headset and the mobile phone.
The headset stores the last eight links in the memory. If you try to
pair more than eight devices, the link for the earliest paired device is
overwritten.
1 Ensure that the headset is charged and turned off.
2 Ensure that the mobile phone is turned on and its Bluetooth
feature is activated.
3 Press until the LED starts ashing red and blue alternately.
Do not stop pressing the button after seeing the blue LED
only.
The headset is in pairing mode, which lasts ve minutes. »
4 Pair the headset with the mobile phone. For details, refer to
the user manual of the mobile phone.
A sample pairing is shown below.
1 Under Bluetooth menu on the mobile phone, search for the
headset.
2 From the found devices, select Philips SHB1400.
Enter “• 0000” (4 zeros), if prompted to enter the pin
code of the headset. On mobile phones using Bluetooth
2.1+EDR or higher, you may not need to enter a pass
code.
When the pairing is successful, a long beep occurs and the »
LED on the headset starts to ash blue every 3 seconds.
Settings Connectivity
Select
Back
Enter Password
Settings
Devices Found
Select
Back
Philips SHB1400
Settings Connectivity
Bluetooth
Select
Back
Add
Bluetooth
device