Filter
Top Products
2 Setting up your phone
Installing your DECT 2250
1. Place 2 rechargeable NiMH AAA batteries (included), in correct
polarities, into the battery compartment on the handset.
Note : the warranty shall not apply to the batteries and any
other components within lifetime and wear.
2. Slide the battery door firmly into place.
3. Place the handset on the base unit or the charger and let the batteries continuously charge for 24hours before
using. A beep indicates that the handset is properly placed on the base unit or the charger. The handset may take
some time to power up and it may get warm during the initial charge.
This is normal.
Select the language
1. Press twice the MENU key. LANGUAGE appears on the screen.
2. Press the
OK key. The current language is shown on the screen.
3. Select the desired language.
4. Press the
OK key to confirm.
If you need to change the language again, see description on page 8.
SETTING UP YOUR PHONE
Registering your handset
You will need to register your handset if it shows NOT REG in the display or if you wish to un-register from its original
base and register the handset to a different base unit. You can register up to 4 handsets to your DECT 221 base station
and DECT 225 base station.
To register your handset:
1. Press the
MENU key.
2. Select
SETTINGS and press the OK key.
3. Select
REGISTERand press the OK key.
4. Before OK key is pressed when
REGISTER is selected, press and hold the PAGING key on the base
for 4 seconds until a registration tone is emitted (DECT 225 only). The base is now in the registration
mode. (If the base is full and cannot take on any more handset, it will emit a reject tone instead (DECT
225 only) and you will not be able to register any more handset. See Section 9 - Un-registering a
handset - to delete a currently registered handset.)
5. Press the OK key while REGISTER is selected.
During the registration period, you will see
SEARCHNG on the handset.
You will hear a confirmation tone if the registration is successful. The handset label and the handset number will be
displayed. If the registration is not successful, the previously unregistered handset will display NOT REG
again and the
previously registered handset will connect back to its original base again. Follow the procedure and try again.
4