Filter
Top Products
35
Useful Information
For assistance, please call: 1-800-211-PANA(7262)
Troubleshooting
Problem Cause and Remedy
The unit does not work. • Check the settings (p. 6 – 14).
• Remove the batteries and reinstall them
to reset the unit.
The unit does not ring. • The ringer selector is set to OFF. Set to
HIGH or LOW (p. 11).
The display is blank. • Install new batteries (p. 34).
You cannot dial. • Check that the dialing mode selection is
correct (p. 10).
• The dialed number is restricted. To
cancel, see page 32.
The other party suddenly
cannot hear your voice
during a conversation.
•
[MUTE]
may have been pressed during
the conversation. If “ ” is displayed,
press
[MUTE]
.
You cannot program items
such as the dialing mode.
• Programming is not possible when the
handset is off the cradle.
• Do not pause for over 60 seconds while
programming.
You cannot store a name
and phone number in
memory.
• When using the Call Restriction feature
(p. 32), you cannot store an emergency
number in the Phone Book List.
• If “
PHONEBOOK FULL
” is displayed,
erase other stored items from the Phone
Book List (p. 28).
• Programming is not possible when the
handset is off the cradle.
• Check that the batteries are installed in
the unit and that the battery power is not
low.
• Do not pause for over 60 seconds while
storing.
• Do not enter a phone number more than
22 digits long.
While programming or
searching, the unit starts to
ring and stops the program/
search.
• To answer the call, lift the handset. Start
again from the beginning after hanging
up.