Filter
Top Products
Page 2 of 4
3- Connect the audio cord from your audio source, to the AUDIO IN jack on the back of
the CK-1 box. For DIGITAL units use the cable that comes with the digital player.
4- Connect a MOD cord from Telephone Wall Jack 1&2 to [1&2 Line on CK-1].
5- Locate the CK-1P3 "SENSOR BOARD", peel off the protector paper from the bottom
of the sensor board, and carefully place it OVER the LINE buttons on the Panasonic base
set as shown in Fig. #2. The buttons on the SENSOR BOARD MUST be centered
directly over the line 1 and 2 selector buttons on the phone. The SENSOR BOARD
MUST be attached to the phone for proper operation.
6- Connect the Sensor Cable to the Sensor Board as shown in fig. 2.
7- Connect the POWER CUBE from the CK-1 box to 115VAC power. That's it!
Fig. 2
Fig. 3
Align Buttons over buttons on phone
Attach cable to Sensor Board