Filter
Top Products
Connections
C
o
nnect the handset cord (A) to the handset and the unit. Connect the telephone
line cord until it clicks into the unit and telephone line jack (B). After line connection,
lift the handset to check for a dial tone.
DSL/ADSL filter*
To single-line telephone
jack (RJ11C)
1
2
R Use only a Panasonic handset for KX-TS840.
R U
se only the supplied telephone line cord. Using another telephone line cord may
not allow the unit to work properly.
*DSL/ADSL filter (not supplied) is required if you have DSL/ADSL service.
Initial setting
Dialing mode
If
you cannot make calls, change this
setting according to your telephone line
service.
The default setting is TONE.
TONE: For tone dial service.
PULSE: For rotary/pulse dial service.
1 Lift the handset.
2 MPROGRAMN
R Status indicator light will start
double flashing at an interval.
3 MHOLD/MODEN ® M3N
4 To select TONE, press M1N.
or
To select PULSE, press M2N.
5 MPR
OGRAMN
R A long beep sounds.
R Status indicator light will turn OFF.
6 When finished, hang up.
For assistance, please visit http://www.panasonic.com/help
7
Preparation