Filter
Top Products
Answering system
Problem Cause/solution
The unit does not record new
me
ssages.
R The answering system is turned off. Turn it on (page 29).
R The message memory is full. Erase unnecessary
messages (page 30).
R The recording time is set to “Greeting only”. Change
the setting (page 33).
R Your service provider/telephone company’s voice mail
service may be answering your calls before the unit’s
answering system can answer your calls. Change the
unit’s number of rings setting (page 32) to a lower value,
or contact your service provider/telephone company.
I cannot operate the answering
sy
stem remotely.
R The remote access code is not set. Set the remote
access code (page 31).
R You are entering the wrong remote access code. If you
have forgotten your remote access code, enter the
remote access code setting to check your current code
(page 31).
R The answering system is turned off. Turn it on (page 32).
The unit does not emit the
sp
ecified number of rings.
R If the first ring is turned off, the number of rings decreases
by 1 from the specified number of rings.
Voice mail
Problem Cause/solution
“New Voice Mail”
is shown
on the handset display. How do
I remove this message from the
display?
R This notification is displayed when your service provider/
telephone company’s voice mail service (not the unit’s
answering system) has recorded a message for you.
Typically you can remove this notification from the display
by listening to the message. To listen to the message, dial
the voice mail number provided by your service provider/
telephone company (for most cases, this will be your own
phone number), and follow the voice instructions.
Depending on your service provider/telephone company,
you may need to remove all messages from your voice
mailbox to remove the notification. You can also remove
this notification by pressing and holding # until the unit
beeps.
40
For assistance, please visit http://www.panasonic.com/help
Useful Information
TGC2xx(en_en)_1209_ver030.pdf 40 2013/12/09 11:46:11