Panasonic KXTGA660B Bluetooth Headset User Manual


 
R D
o not touch the handset’s charge
contacts during power back-up mode.
R If the battery level is low, the unit will
not work sufficiently during power
back-up mode. In addition, in case
handset battery power runs out, we
recommend connecting a corded-type
telephone (without AC adaptor) to the
same telephone line or to the same
telephone line jack using a Panasonic
T-adaptor (page 5).
Panasonic Ni-MH battery
p
erformance (supplied batteries)
during power back-up mode
When the batteries are fully charged,
operating time of the handset in power
back-up mode varies depending on
usage.
Continuous use of the handset in
power back-up mode: 2 hours max.
Continuous use of the handset other
than a handset in power back-up
mode: 3 hours max.
Not in use in power back-up mode: 3
hours max.
Note:
R Actual battery performance depends
on usage and ambient environment.
Making calls during a power
f
ailure
n When only 1 handset is registered:
1 Lift the handset and dial the
phone number.
2 Within 1 minute, place the
handset on the base unit.
R Wait until speakerphone is
turned on automatically and
the call is made.
3 When the other party answers
the call, keep the handset on the
base unit and talk using the
speakerphone.
4 W
hen you finish talking, press
MOFFN.
Note:
R In step 2, if you do not place the
handset on the base unit within 1
minute, the power back-up mode
turns off. In this case, press MOFFN on
the handset and dial the phone
number. Then try again from step 2.
n When 2 or more handsets are
registered:
You should leave one handset on the
base unit for supplying the power,
and use another handset for making
calls. For the operation, please see
“Making landline calls”, page 24.
Note:
R During a call with the handset placed
on the base unit (power back-up
mode), the call may be disconnected
if you touch the handset. In such
case, try to call back.
R The range of the base unit is limited
during a power failure. Please use the
handset close to the base unit.
Making a call using the redial list
n W
hen only 1 handset is registered:
1 Lift the handset.
2 MEN REDIAL
3 MbN: Select the desired phone
number.
4 Within 1 minute, place the
handset on the base unit.
R Wait until speakerphone is
turned on automatically and
the call is made.
n When 2 or more handsets are
registered:
You should leave one handset on the
base unit for supplying the power,
For assistance, please visit http://www.panasonic.com/help
29
Making/Answering Calls Using the Handset