Filter
Top Products
2 E
nter the desired name (max. 10
characters; see the character table,
page 30).
R If not required, go to step 3.
3 MSAVEN
4 MbN: Select the desired setting. a
MSELECTN 2 times
5 MOFFN
Call block (Caller ID subscribers
only)
This feature allows the unit to reject calls when:
– the unit receives a call from a phone
number stored in the call block list as
unwanted (“Storing unwanted callers”,
page 41).
– the unit receives a call without phone
number (“Blocking incoming calls without
phone number”, page 41).
When a call is received, the unit rings for a
short time while the caller is being identified. If
the phone number matches an entry in the call
block list:
– cellular calls are rejected.
– landline calls are disconnected after the
unit first sends out a busy tone to the caller.
Important:
R When the unit receives a call from a
number that is stored in the call block list or
a call without a recognized phone number,
the call is logged in the caller list
(page 44) with after the call is
d
isconnected.
Storing unwanted callers
You can store up to 30 phone numbers in the
call block list.
Important:
R We recommend storing 10 digits (including
an area code). If only 7 digits are stored, all
numbers that have the same last 7 digits
will be blocked.
n From the caller list:
1 MFN CID
2 MbN:
Select the entry to be blocked.
R To edit the number, press
MSELECTN, then press MEDITN
repeatedly until the phone number
is shown in the 10-digit format.
3 MSAVEN
4 MbN: “Call block” a MSELECTN
5 MbN: “Yes” a MSELECTN
6 Edit the phone number if necessary
(24 digits max.).
7 MSAVEN a MOFFN
n By entering phone numbers:
1 MMENUN#217 a MADDN
2 Enter the phone number (24 digits
max.).
R To erase a digit, press MCLEARN.
3 MSAVEN a MOFFN
Blocking incoming calls without
p
hone number
You can reject a call when no phone number
is provided, such as a call just showing “Out
of area”.
1 MMENUN#240
2 MbN: Select the desired setting. a
MSAVEN a MOFFN
Viewing/editing/erasing call block
n
umbers
1 MMENUN#217
2 MbN: Select the desired entry.
R To exit, press MOFFN.
3 To edit a number:
MEDITN a Edit the phone number. a
MSAVEN a MOFFN
To erase a number:
MERASEN a MbN: “Yes” a MSELECTN
a MOFFN
Note:
R When editing, press the desired dial key to
add, MCLEARN to erase.
R When viewing, “Block w/o num” is
displayed if the blocking incoming calls
without phone number feature is turned on.
For assistance, please visit http://www.panasonic.com/help
41
Programming
TG7731_41_(en-en)_1121_ver.021.p41 41 2011/11/21 12:02:14