Filter
Top Products
Troubleshooting
I
f you still have difficulties after following the instructions in this section, disconnect
the base unit’s AC adaptor, then reconnect the base unit’s AC adaptor. Remove the
batteries from the handset, and then insert the batteries into the handset again.
General use
Problem Cause/solution
The handset does not turn
o
n even after installing
charged batteries.
R Place the handset on the base unit or charger to
turn on the handset.
The unit does not work. R M
ake sure the batteries are installed correctly
(page 9).
R Fully charge the batteries (page 10).
R Check the connections (page 9).
R Unplug the base unit’s AC adaptor to reset the
unit. Reconnect the adaptor and try again.
R The handset has not been registered to the base
unit. Register the handset (page 31).
I cannot hear a dial tone. R T
he base unit’s AC adaptor or telephone line cord
is not connected. Check the connections.
R Disconnect the base unit from the telephone line
and connect the line to a known working
telephone. If the working telephone operates
properly, contact our service personnel to have
the unit repaired. If the working telephone does
not operate properly, contact your service provider/
telephone company.
The indicator on the
h
andset flashes slowly.
R New messages have been recorded. Listen to the
new messages (page 37).
R New voice mail messages have been recorded.
Listen to the new voice mail messages (page 42).
The receiver volume is
c
hanged to level 4
(default), even though I set
it to level 5 (maximum
level).
R The receiver volume returns to level 4 after you
hang up. Press MjN or MkN to adjust the volume
every time or as needed.
Programmable settings
Problem Cause/solution
The display is in a
l
anguage I cannot read.
R Change the display language (page 14).
48
For assistance, please visit http://www.panasonic.com/help
Useful Information