Filter
Top Products
Answering System
Preparation
47
For assistance, please call: 1-800-211-PANA(7262)
Telephone System Useful Information
Troubleshooting
If the handset display shows error messages, see “If the Following Appear on
Your Display...” (p. 46) for the Cause & Remedy.
Problem Cause & Remedy
“No link to base.
Move closer to
base and try
again.” is displayed and an
alarm tone sounds.
• You are too far form the base unit. Walk
closer to the base unit, and try again.
• Confirm the base unit’s AC adaptor is
plugged in.
• Raise the base unit antennas.
• If the above remedies do not solve the
problem, the handset may have lost
communication with the base unit. Re gister
the handset again (p. 40).
The handset and/or base unit
does not work.
• Check the settings (p. 9–11).
• Check whether the dialing mode setting is
correct (p. 14).
• Fully charge the battery (p. 10).
• Clean the charge contacts and charge again
(p. 11).
• Check battery installation (p. 10).
• Unplug the base unit’s AC adaptor to reset it.
Plug in, and try again.
• Re-install the battery (p. 10) and fully charge
it.
St atic, sound cuts in/out,
fades. Interference from other
electrical units.
• Move the handset and base unit away from
other electrical appliances (p. 3).
• W alk closer to the base unit.
• Raise the base unit antennas.
• T urn on the Clarity Booster feature (p. 21).
The handset does not ring. • The ringer volume is turned off. Set to high,
medium, or low (p. 16).
The handset display is blank. • If the handset display is blank, fully charge
the battery (p. 10).
You cannot program any
function items.
• Programming is not possibl e while the
handset is being used.
• Do not pause for over 60 seconds while
programming.
• W alk closer to the base unit.
While programming or
searching, the handset starts
to ring and the program/
search stops.
• A call is coming in. To answer the call, press
[C] or [s]. St art again from the beginning
after hanging up.
TG5055.fm.fm Page 47 Tuesday, January 27, 2004 3:18 PM