Filter
Top Products
Programming
29
Programming using the direct commands
1 {MENU}
2 Enter the desired feature code.
3 Enter the desired setting code.
L This step may vary depending on the
feature being programmed.
4 {Save} i {OFF}
Note:
L In the following table:
– < > shows the default setting.
– If “System setting” column is checked,
you do not need to programme the
same item using another handset (KX-
TG2622).
L If you make a mistake or enter the wrong
code, press {OFF}, then start again by
pressing {MENU}.
Feature Feature
code
Setting code System
setting
Auto talk
*1
{0}{3}{1}: On {0}: <Off>–
Copy phonebook (1 item)
*2
{#}{1} (page 23) –
Copy phonebook (All items)
*2
{#}{2} (page 23) –
Dial lock {6} (page 20) r
Interrupt tone
*3
{1}{3}{1}: On {2}: <2> {0}: Off –
Key tone
*4
{0}{2}{1}: <On> {0}: Off –
LCD contrast
(Display contrast)
{0}{1}{1}–{6}: Level 1–6 <3> –
Registration {0}{0} (page 33) –
Ringer tone (Handset) {1}{2}{1}–{3}: Tone <1>–3
{4}–{7}: Melody 1–4
–
Ringer volume (Handset) {1}{1}{1}: Low {2}: Medium
{3}: <High> {0}: Off
–
Set area code {0}{4} (page 25) –
Set dial mode {0}{5}{1} (page 39) r
Set line mode
*5
{0}{5}{3}{1}: A {2}: <B> r
TG2621AL_2622AL.book Page 29 Monday, February 20, 2006 3:40 PM