Filter
Top Products
5
Registering a Handset to the Base Unit
•
You must register the Handset to the base unit before use.
•
To exit the operation, press at any time.
1
Press
JOYSTICK
(or move).
2
Select “
Setting Handset
”.
3
Select “
Registration
”.
4
Select “
Register H/set
”.
5
Press and hold on the Base unit (for about 3 seconds) until
the tone sounds.
If all registered handsets start ringing (Paging), press to stop
paging then start over again.
6
Select the desired base unit.
7
Enter 4-digit Base Unit PIN after
“
Enter Base PIN
”
is displayed.
Factory preset 0000
8
Press
JOYSTICK
.
When a handset is registered successfully, a
confirmation tone sounds and “ ” icon lights.
TCA151EX.book Page 5 Monday, June 9, 2003 7:14 PM