Filter
Top Products
Before Requesting Help
40
Problem
You cannot program items,
such as the ringer volume.
Previously programmed
information is erased.
You cannot store a name and
phone number in the directory.
While programming or
searching, the unit starts to
ring and stops the
program/search.
The unit does not display the
caller’s phone number.
The display goes to the
standby mode while viewing
the Caller List/directory list.
You cannot redial the last
number dialled
.
Remedy
• Programming is not possible while the
unit is in the talk mode or when viewing
the Caller List/directory list.
• Do not pause for over 60 seconds
while programming.
• Move closer to the base unit.
• If a power failure occurs, programmed
information may be erased. Reprogram
if necessary.
• You cannot store an item in the
directory
while the unit is in the talk
mode.
• Do not pause for over 60 seconds
while storing.
• To answer the call, press
(TALK).
Start again from the beginning after
hanging up.
• Other telephone equipment may be
interfering with your phone. Disconnect
it and try again.
• Other electrical appliances connected
to the same outlet may be interfering
with the Caller ID information.
• Telephone line noise may be affecting
the Caller ID information.
• Some PABX do not support Caller
Display.
• Do not pause for over 60 seconds
while searching.
• If the last number dialled was more
than 32 digits long, the number will not
be redialled.