Filter
Top Products
monitor feature is set correctly. For
example, test its sensitivity. Check the
connection if you are diverting the baby
monitor to an outside line.
Note:
R If the unit is connected to a PBX system,
you cannot set the baby monitor.
R During the monitoring mode, battery
consumption is faster than usual. We
recommend leaving the monitored handset
on the base unit or charger.
R The monitored handset never rings during
the monitoring mode.
Setting the baby monitor
Perform the setting operation with the handset
to be monitored (for example, the handset
placed in a baby’s room).
To monitor with a handset
The internal baby monitor feature is only
available between handsets in the same radio
cell.
1 MMenuN (right soft key) #268
2 MbN: “On” a MSelectN
3 MbN: Select the desired handset number
to monitor with. a MSaveN
R “Baby monitor” will be displayed.
R The registered handset name/number
is displayed.
Note:
R You can also select your smartphone in this
feature using a handset, if your smartphone
is registered to the base unit (page 42).
R When this feature is on, another handset
can hear the monitored handset by making
an intercom call.
To monitor from an outside line
n From the phonebook:
1 MMenuN (right soft key) #268
2 MbN: “On” a MSelectN
3 MbN: Select “External” to monitor
from an outside line. a MEditN a
MAddN
4 MbN: “Phonebook” a MSelectN
5 MbN: Select the phonebook entry. a
MSelectN
6 MbN: Select the desired phone number.
a MSaveN
R “Baby monitor” will be displayed.
Note:
R If you edit a phonebook entry which is
assigned for monitoring, the edited entry
does not transfer to the monitor.
n By entering phone numbers:
1 MMenuN (right soft key) #268
2 MbN: “On” a MSelectN
3 MbN: Select “External” to monitor
from an outside line. a MEditN a
MAddN
4 MbN: “Manual” a MSelectN
5 Enter the desired name. a MOKN
6 Enter the desired number. a MOKN
a MSelectN
R “Baby monitor” will be displayed.
Note:
R The registered name/number is displayed.
Turning off the baby monitor
The monitored handset cannot be used while
baby monitor is set to “On”.
1 Press MMenuN on the handset being
monitored.
2 MbN: “On/Off” a MSelectN
3 MbN: “Off” a MSelectN a MOFFN
Editing an outside monitoring number
1 Press MMenuN on the handset being
monitored.
2 MbN: “On/Off” a MSelectN
3 MbN: “On” a MSelectN
4 MbN: Select the outside line. a MEditN
5 MMenuN a MbN: “Edit” a MSelectN
6 Edit the name if necessary. a MOKN
30
For assistance, please visit http://www.panasonic.com/help
Programming
PRW120(en)_1016_ver041.pdf 30 2013/10/16 10:40:18