Filter
Top Products
R D
o NOT use Alkaline/Manganese/Ni-Cd batteries.
R Confirm correct polarities (
, ).
C
harge for about 7 hours.
R Confirm “Charging” is displayed (
2
).
R When the batteries are fully charged, “Fully charged” is displayed.
1
2
Note:
R I
f the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends (
, ) and the charge contacts with a dry cloth and
c
harge again.
Registering a handset to a base unit
1 Base unit:
Press and hold M N
for about 5 seconds.
R If all registered handsets start ringing, press M
N
again to stop, then repeat
this step.
2 Handset:
Place the handset on the base unit or charger, then wait until a long beep
sounds and
is displayed.
N
ote:
R If an error tone sounds, or if
is displayed, register the handset according to
t
he base unit’s operating instructions.
Display language
1 MM
ENUN (right soft key) #110
2 MbN: Select the desired setting. a MSAVEN a MOFFN
For assistance, please visit http://www.panasonic.com/help
3
Installation
PRLA20_IM_(en_en)_1219_ver030.pdf 3 2013/12/19 22:31:03