Filter
Top Products
4 Document Version 2009-03
Wall Mounting
CAUTION:
Do not mount this unit on a wall while attached to a DPT.
Doing so may damage the wall mounting adaptor or, may cause
the unit to fall, possibly resulting personal injury.
1.
Remove
the wall mounting
adaptor
from the unit as shown.
2.Set the operation board to level
1, then connect and secure the
telephone line cord.
3.Attach the wall mounting adaptor
as shown.
• Make sure the cord is not pinched
by the wall mounting adaptor.
When running the cord from the top
of the unit, look through the
opening in the wall mounting
adaptor (A) to confirm that the
cord is not being pinched.
4.
Drive the 2 screws (included) into
the wall either 83 mm (3-1/4 in) or
100 mm (3-15/16 in) apart, and
mount the unit on the wall.
• You can find a wall mounting
template on page 8.
• Make sure that the wall that the unit
will be attached to is strong enough
to support the unit (approx. 1 kg
[2.2 lb]).
• Make sure the cord is securely
fastened to the wall.
• When this unit is no longer in use,
make sure to detach it from the
wall.
83 mm
(3-1/4 in)
100 mm
(3-15/16 in)
Washer
Drive the screw
to this point.
DT390M_QRG.fm Page 4 Friday, February 27, 2009 11:02 AM