Filter
Top Products
Useful Information
44 For assistance, please visit http://www.panasonic.com/help
Making/answering calls, intercom
Problem Cause/solution
w is flashing. LThe handset is not registered to the base unit.
Register it (page 38).
LThe handset is too far from the base unit. Move
closer.
LThe base unit AC adaptor is not connected.
Check the connections.
LYou are using the handset or base unit in an
area with high electrical interference. Place the
handset and base unit away from interference
sources, such as antennas and mobile phones.
w is displayed, but I
cannot make a call.
LThe handset and base unit could not
communicate for some reason, such as
interference from other electrical appliances.
Perform the following:
– Move the handset and base unit away from
other electrical appliances.
– Move closer to the base unit.
Static is heard, sound cuts
in and out. Interference
from other electrical units.
LPlace the handset and the base unit away from
other electrical appliances.
LMove closer to the base unit.
LIf your unit is connected to a telephone line with
DSL service, we recommend connecting a noise
filter between the base unit and the telephone
line jack. Contact your DSL provider for details.
Noise is heard during a
call.
LYou are using the handset or base unit in an
area with high electrical interference. Place the
handset and base unit away from interference
sources, such as antennas and mobile phones.
The handset does not ring. LThe ringer volume is turned off. Adjust the ringer
volume (page 27).
I cannot make a call. LThe dialing mode may be set incorrectly.
Change the setting (page 15).
LAnother handset is in use or the answering
system is being used. Wait and try again later.
I cannot have a
conversation using the
headset.
LMake sure that an optional headset is
connected properly (page 40).
I cannot make long
distance calls.
LMake sure that you have long distance service.
TG8231_8232.book Page 44 Thursday, July 19, 2007 3:22 PM