Filter
Top Products
Answering System
59
For product assistance, visit www.panasonic.com/help
For A assistance, visit www.joip.com
Operating the answering
system
*1 If pressed within the first 5 seconds of
a message, the previous message is
played.
Erasing all messages
Press {ERASE} 2 times while the unit is
not being used.
L All messages including voice memos
are erased.
Erasing all messages for the desired
line(s)
1 Press {IP/TEL} repeatedly until the
display shows the desired line(s)
(n and/or m).
2 Press {ERASE} 2 times.
Listening to messages
using the handset
When new messages have been
recorded:
– “New message” is displayed.
– The message indicator on the handset
flashes slowly if the message alert
feature is turned on (page 64).
1 {MENU} i {PLAY}
L The handset plays new messages
including voice memos.
L When you have no new
messages, the handset plays
back all messages.
2 When finished, press {OFF}.
Note:
L You can also listen to the messages
as follows:
To play new messages:
{MENU} i {#}{3}{2}{3}
To play all messages:
{MENU} i {#}{3}{2}{4}
L To switch to the receiver, press {s}.
Calling back (Caller ID subscribers
only)
If Caller ID information was received for
the call, you can call the caller back
while listening to the message.
1 Press {SELECT} during playback.
L k To edit the number before
calling back, press {EDIT}
repeatedly until the phone
number is shown in the desired
format (page 44).
L l To edit the number before
calling back, press {EDIT}. Then
add or erase digits to the
beginning of the number by
pressing the desired dial key or
{CLEAR}.
Key Operation
{^} or {V} Adjust the speaker
volume
(during playback)
{<} Repeat a message
(during playback)
*1
{>} Skip a message
(during playback)
{STOP} Pause a message
– To resume playback,
press {6} (center of
navigator key).
– To stop playback
completely, press
{STOP} again.
{ERASE} Erase message
currently playing
GT15xx.book Page 59 Wednesday, August 8, 2007 10:30 AM