Filter
Top Products
1.2 Quick Setup
The Oricom TP6 telephone is used like any conventional
telephone and works with all modern telephone exchanges
using the tone dialling system. Plug one end of the line
cord into the bottom of the phone and the other into the
wall socket using the plug supplied.
1.3 Check contents of pack
The following items are supplied in this pack:
one telephone base one telephone handset
one short telephone cable one long telephone cable
one warranty card one operating Manual
1.4 Connect the line cord
Plug one end of the telephone cable (long for desk
installation) into the wall socket. Plug the other end into the
socket located in the indentation on the base of the
telephone. Then feed the cable through the cable guide.
1.5 Wall mounting
Method A. At the desired location drill two holes one above
the other, 83mm apart, use two screws (not supplied) for
fixing and leave them protruding 5mm from the wall. Now
place the telephone base over the screws and gently push
forwards and then downwards.
Method B If you wish to fit to an existing telephone wall
plate with modular connector simply plug in the short
telephone line cord into the base of the phone and plug the
other end into the telephone wall plate socket. Position the
mounting holes on the base of the phone over the two
protruding screws on the wall plate. Gently push the phone
flush against the wall plate then slide the phone downwards
locking it into place.
4