Filter
Top Products
More on your T7316E telephone
Audio cluster buttons
©
Mute button
Turns the microphone off or on when you are on a call.
Handsfree button
For more information on using the handsfree feature,
refer to the “Handsfree calls” section in this card.
¬
Headset button
Turns the headset mode on.
≤
Feature button
Starts or ends a feature.
≥
Hold button
Places calls on hold.
Memory buttons
Memory and line buttons
Indicators
Appear next to active line and memory buttons.
Number card
Write your extension number on this card.
Feature card plate
Storage compartment for your feature card.
G
H
I
J
K
L
M
N
T7316E Telephone User Card
1-800-4 NORTEL
www.nortelnetworks.com
© 2004 Nortel Networks
P0609623 01
Printed in Canada
A
B
C
D
E
F
H
J
K
L
M
J
K
G
I
N
Cord connections
Wall mount without a telephone stand
1
Desk mount option
Route line cord through the stand.
Headset option
Connect cord to
headset.
Connect cord
to handset.
Connect line cord
to wall jack.
2
3
Slide feature card plate down.
Warning
The earpiece/mouthcap region
on the handset may attract
and retain small objects.
Press here to remove the stand.
Place the telephone onto
the wall mount plate and
slide it down.
Connect line cord to
wall jack.
1
2
Connect cords to the telephone,
refer to “Cord connections”
illustrations.
Your T7316E telephone
Telephone light
Flashes for incoming calls.
Lights up when Message Waiting Indication (MWI) is
supported by system software. Contact your system
administrator for more information.
Adjustable tilt display
Shows the time and date, call and feature information.
Display buttons
The label for display buttons appear in capital letters
on the bottom of the display. Display buttons change
with each feature you use.
®
Release button
Ends an active call or feature.
Dial pad
√
Volume control
Adjusts the handset, handsfree, headset and ringer
volume.
A
B
C
Feature message
Display button
Contrast level 2
Display button label
DO
WN UP OK
D
E
F
Wall mount with a telephone stand
Mount the telephone
onto the screws and
slide it down.
Press here to remove the stand.
1
Mount the stand as shown.
Use the key hole slots on the stand
to mark the location for the screws.
key hole slots
2
3
Connect line cord to
wall jack.
Connect cords to the telephone,
refer to “Cord connections”
illustrations.
Tighten screws for a secure fit.
Display contrast level
Adjust the contrast of your display.
1. Press
≤•‡
.
2. Press
UP
or
DOWN
to view the levels.
3. Press
OK
to select a level.
Language choice
≤•fi‚⁄
Select Primary Language for the telephone display.
≤•fi‚¤
Select Alternate Language for the telephone display.
≤•fi‚‹
Select Alternate Language 2 for the telephone display.
≤•fi‚›
Select Alternate Language 3 for the telephone display.
Ring type
Select a different ring for your telephone.
1. Press
≤•fl
.
2. Press
⁄
,
¤
,
‹
,
›
or
NEXT
to hear the different
ring types.
3. Press
OK
to store the ring type.
Telephone setup
Return
to Menu