Filter
Top Products
-8-
To assign your phone to a base station:
If your installer has already set up a base station, obtain the security code,
and perform steps 1 to 7 of this procedure.
If you need to assign a security code to the base station, perform all the
steps in this procedure.
1. Press the Options/Mute button.
2. Press the SHOW softkey.
3. Press the NEXT softkey until the display shows "4. Set S.S. Code".
4. Press the SHOW softkey. The display shows "Press 6 digits".
5. Using the keypad, enter the 6-digit security code assigned to the base
station you are connecting to.
6. Press the OK softkey. The display shows "4. Set S.S. Code".
If you are assigning a phone to an existing base station, your phone is
now connected to the system.
If you are assigning the first phone to a new base station (which has no
security code), continue with the following steps.
7. When the display shows "4. Set S.S. Code", press the NEXT softkey to
get ready to send the security code to the base station. The display
shows "5. Send S.S. Code".
8. Unplug the AC power adapter connected to the base station, and plug it
back in again.
9. Within 15 seconds, press and hold the OK softkey for 5 seconds to send
the security code to the base. When the transfer is successful, the display
shows "Send OK!" and you hear a beep.
Note: If the security code transfer fails, the display shows "Send Error!".
To correct this, repeat steps 9 and 10.
0. Press the Options/Mute button. The display shows the time and date.