Filter
Top Products
BATTERY INSTALLATION
Your LXT112 Series radio operates with 3 AAA alkaline batteries or a NiMH
rechargeable batteries. The belt clip should be removed to ease installa-
tion or removal of the batteries.
To install the batteries:
1. With the back of the radio facing you, remove the belt clip (see diagram
below) for easy access, then remove the Battery Cover by pressing
down on the top center and sliding it down from the radio.
2. Insert 3 AAA batteries observing the polarity as shown on the Battery
Compartment. Installing the batteries incorrectly will prevent the unit
from operating or may damage the unit.
3. Return the Battery Cover by sliding it up on the radio. Replace the belt
clip, making sure it locks into place.
BATTERY
COMPARTMENT
BATTERY
COMPARTMENT
COVER
Press here and
push down to open
BELT CLIP
LOCK TAB
BELT CLIP
LATCH
CHARGING THE BATTERY
Your LXT112 Series is equipped for using rechargeable NiMH batteries
which can be recharged by inserting the AC adapter into the radio charge
jack. Initial charge time is 24 hours. Charge time is about 12 hours
thereafter. For maximum battery life, we recommend charging the bat-
teries when the low battery icon comes on. Remove the radios from the
charger when the charge time expires.
1. Only use our NiMH batteries.
2. Do not attempt to charge alkaline batteries or any batteries or
battery packs other than the one indicated in the manual. This
may cause leakage and damage to the radio.
3. For long term storage of the radio, turn the radio OFF and
remove the batteries from the radio.
EXTERNAL SPEAKER/MICROPHONE JACK
To use an optional speaker / microphone or headset:
l Insert the plug(s) into the SPK/MIC jacks
l Place the earbud into your ear, and adjust the mic into
your desired position.
!
SPK
MIC
CHG