Lucent Technologies 362EC Telephone User Manual


 
Copyright 1998 Lucent Technologies
All rights reserved
Printed in U.S.A.
Comcode 108272832
June 1998 (Issue 1)
PARTNER is a registered trademark
of Lucent Technologies
362EC Line/
Extension
Module
Only for use on the Lucent Technologies PARTNER
Endeavor Communications System
Installation Instructions
Important Safety Instructions
!
WARNING:
The following list provides basic safety precautions that should always be followed when using your
telephone equipment:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the equipment.
3. Unplug all telephone connections before cleaning. DO NOT use liquid cleaners or aerosol cleaners. Use a
damp cloth for cleaning.
4. The product should be serviced by (or taken to) a qualified repair center when service or repair work is
required.
5. DO NOT use the product near water, for example, a wet basement location.
6. Never push objects of any kind into the slots or openings as they may touch dangerous voltage points or
short out parts that could result in a risk of fire or electric shock. Never spill liquid of any kind on the
equipment. Doing so may result in serious damage to the components.
7. DO NOT use the telephone to report a gas leak in the vicinity of the leak.
8. The telephone equipment is provided with a three-wire grounding type plug. This is a safety feature. DO NOT
defeat the safety purpose of the grounding type plug. DO NOT staple or otherwise attach the power supply
cord to building surfaces.
!
CAUTION:
DO NOT block or cover the ventilation slots and openings. They prevent the product from overheating. DO
NOT place the equipment in a separate enclosure unless proper ventilation is provided.
Additional Safety Instructions for Installation Personnel
1. Install the equipment to meet all the environmental and electrical requirements listed in the
PARTNER
Endeavor Installation Guide
.
2. DO NOT install equipment during a lightning storm.
3. DO NOT install telephone jacks in a wet location unless the jack is specifically designed for wet locations.
4. Never touch uninsulated telephone wires or terminals, unless the telephone line has been disconnected at
the network interface.
5. Use caution when installing or modifying telephone lines.
6. The control unit must be securely wall mounted.
362EC
Module
7-foot
Line Cords
COMBO
COMBO
COMBO
COMBO