Logitech Mobile Speakerphone P710e
English 7
Initial setup of device
•The very first time you use the P710e,
you must either connect it into a PC or
an AC outlet.
Setup with a computer
•Connect the USB cable from the P710e into
your PC.
•Ensure that the P710e is selected as the
default audio device in your OS settings and
in your application.
Setup with a Bluetooth device
•Press and hold Power button to turn ON
the device. The blue lights start flashing in
a clockwise circle.
•Place your mobile device in pairing mode
and pair to the P710e. You may pair up to
eight Bluetooth devices with only two active
at the same time.
•If you have an NFC enabled device, position
it near the NFC target area on the P710e.
You should see a message on your phone
asking if you would like to pair to the P710e.
– P710e must be powered on.
– Note, position your NFC enabled device
near the NFC target area a second
time to disconnect from the P710e.
This is helpful if you’re still in range
of the P710e, but want to handle calls
on the mobile device.
– Repeat the procedure again
to reconnect.
USB
USB